How to: Replace Parts on a Pit Boss Pellet Grill

This instructional video from www.grillpartsforless.com shows how to access and remove all of the common parts on a Pit Boss Pellet Grill. All of their grills use the same auger feed motor, combustion air fan, burnpot, and igniter. They all use the same RTD probe, however, models with a vertical controller have the RTD wire mounted with screw terminals and the horizontal controllers will connect via a wire disconnect plug fitting. The only tools required to access these parts are a #2 Phillips screwdriver, some wire snips to cut the zip-ties and a bucket to rest the burner assembly on. Timestamps: 0:00 Beginning 0:08 Tools Required 0:22 Remove the Lower Access Panel 0:26 Remove the Side Cover Screws 0:30 Rest Burner Assembly on Bucket 0:36 Cut Zip-Ties 0:42 Pit Boss Pellet Grill Wiring Diagram 0:48 Pit Boss Pellet Grill RTD Probe Connection Locations 0:58 Replacing a Pit Boss Pellet Grill RTD Probe 1:20 Replacing a Pit Boss Pellet Grill Igniter and Burn Pot 1:47 Replacing a Pit Boss Pellet Grill Auger Motor & Feed System Parts 2:15 Replacing a Pit Boss Pellet Grill Combustion Air Fan Motor Parts in this Video: Pit Boss Pellet Grill RTD Probe: https://bit.ly/3aA8WEK Pit Boss Pellet Grill Auger Feed Motor: https://bit.ly/2S3xGyy Pit Boss Pellet Grill Burn Pot: https://bit.ly/2XZKZUF Pit Boss Pellet Grill Hot Rod Igniter: https://bit.ly/3cI6MUX Pit Boss Pellet Grill Combustion Air Fan Motor: https://bit.ly/3cFfnaO Pit Boss Pellet Grill Control Board: https://bit.ly/3aAlPOU Grill Parts for Less Website: https://grillpartsforless.com Please ask questions below in the comments section and subscribe to our channel.

Category